1
Download ssdcp 2005 manual
Transcript
SSDCP Manual Shear Bars SHEAR BARS FOR WF or CHANNEL BEAMS NOTES: TYPE 1 – Holes can be inside or outside of flanges, plate not fitted. TYPE 2 – Holes are normally inside flanges, but edge of plate must extend a little bit beyond flanges. Clipped corners cheaper to fabricator than types 3 or 4. TYPES 3 or 4 – Holes can be inside or outside of flanges, plate must extend beyond flanges. Notched plate more expensive to fabricator than type 2. TYPE 5 – Holes must be inside flange, uses standard stiffener bar width only.
