Download PG-31 GPS Engine Board

Transcript
PG-31 GPS Engine Board User’s Manual & Reference Guide
1. Introduction to PG GPS series
4
PG-31 GPS Receiver
4
Quick View on Specifications
2. Specifications
PG-31
4
5
5
3. Interface Description and Options
Physical Diagram
Digital Interface Connector pin description
PG-31
Option Descriptions
TricklePower Option
RS-232 I/O Option
4. SiRF Binary Protocol Specification
6
6
6
6
8
8
9
9
Protocol Layers
Transport Message
Transport
Message Validation
9
9
9
9
Payload Length
Payload Data
Checksum
Input Messages for SiRF Binary Protocol
Initialize Data Source - Message I.D. 128
Switch To NMEA Protocol - Message I.D. 129
Set Almanac – Message I.D. 130
Software Version – Message I.D. 132
Set DGPS Source – Message I.D. 133.
Set Main Serial Port - Message I.D. 134
Mode Control - Message I.D. 136
DOP Mask Control - Message I.D. 137
DGPS Control - Message I.D. 138
Elevation Mask – Message I.D. 139
Power Mask - Message I.D. 140
Editing Residual– Message I.D. 141
Steady State Detection - Message I.D. 142
Static Navigation– Message I.D. 143
Poll Clock Status – Message I.D. 144
Set DGPS Serial Port - Message I.D. 145
Poll Almanac - Message I.D. 146
Poll Ephemeris - Message I.D. 147
Flash Update - Message I.D. 148
Set Ephemeris - Message I.D. 149
Switch Operating Modes - Message I.D. 150
Set TricklePower Parameters - Message I.D. 151
Computation of Duty Cycle and On Time
Push-to-Fix
Poll Navigation Parameters - Message I.D. 152
Set UART Configuration – Message I.D.165
Low Power Acquisition parameters - Message I.D. 167
Output Messages for SiRF Binary Protocol
Measure Navigation Data Out - Message I.D. 2
Measured Tracker Data Out - Message I.D. 4
Raw Tracker Data Out - Message I.D. 5
9
10
10
10
11
11
12
13
13
15
15
16
16
17
17
17
17
17
18
18
18
19
19
20
20
21
21
22
22
22
24
24
25
26
29
© 2005 by Laipac Technology Inc. All Rights Reserved.
Page 2of 46