Download AC Clamp Meter
Transcript
OPERATING INSTRUCTIONS Notice: Read and understand all WARNING and CAUTION statements listed in the safety section of this operation manual prior to using this meter. Set the function select switch to the OFF position when the meter is not in use. NOTES: 1. ALWAYS turn the rotary function switch to the OFF position when the meter is not in use 2. If “OL” appears in the display during a measurement, the value exceeds the range you have selected. Change to a higher range AC CURRENT MEASUREMENTS WARNING: Disconnect the test leads from the meter before making current clamp measurements. 1. Set the Function switch to the 400AAC, 200AAC, 20AAC or 2AAC range. If the range of the measured current is not known, select the higher range first then move to the lower range if necessary. Yes 2. Press the trigger to open jaw. Fully enclose one conductor to be measured. Note: Do not put more than one wire inside the current clamp. 3. The clamp meter LCD will display the reading. No 10