Download INSTALLATION AND OPERATION MANUAL

Main menu
Page 21/46
6. Main menu
Following menu structure is available:
 Meter setup
 Measure
 Outputs
 Communication
 Misc
 Info
 PIN
Meter Setup
Calibration
This figure is used for setting pipe’s diameter (size).
Several sizes from DN 15 to DN 600 can be set.
Diameter
[Diameter]
Note: Pipe diameter is set at the factory. Changes
of size have an impact on meter’s accuracy.
U
This parameter is set at the factory. This factor
compensates for accuracy error as a result of the
installed detector. If accuracy adjustment of the
meter is required, please refer to the scale factor.
Detector
Factor
[Det Fact]
A
In the event the amplifier is replaced, this parameter
must be reprogrammed with the original detector
factor.
This parameter is set at the factory. This factor
compensates for accuracy error as a result of the
installed detector. If accuracy adjustment of the
meter is required, please refer to the scale factor.
Detector
Offset
[Det Zero]
A
This parameter is set at the factory. This factor
compensates for accuracy error as a result of the
installed amplifier.
Amplifier
Factor
[Amp Fact]
Read only
Coil Current
[Coil Cur]
Read only
This parameter is set at the factory. This factor
compensates for accuracy error as a result of the
installed amplifier.
MID_M5000_BA_02_1304