Download IF1000 User Manual EN V2.2

IT Infrastructure IF1000
6.4
CALLING UP THE DEVICE WEB INTERFACE
To access and open the device web interface, start up your web browser. In the browser’s
address bar, enter the following IP address then confirm with Enter
http://192.168.0.254
LOGIN
Once the IP address has been entered with success, the login prompt appears. In the login
prompt, entry of the default settings is required.
The default configuration in just-delivered conditions is:
USER NAME :
admin
PASSWORD :
admin
Confirm your entries by clicking on: OK
Note:
If the login prompt does not appear, check to ensure that the device has been connected
via a RJ45/LWL optic fibre connection cable. Otherwise, connect the device up to a PC
(Device LAN-in/LAN-out connection <> PC LAN connection).
If there still is no connection to the firewall login prompt, it is necessary to check the
proxy and local firewall settings. It often occurs that also local subnet addresses ( e.g.
192.168.x.x) are diverted to a proxy server. In this case it is possible to select the
“Bypass proxy server for local addresses” option to enter the address in question.
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
45