Download "user manual"

HelvC NugFont
Co d e 39 Operating the Terminal in a Network
4
Configuring the Model 200 Controller
The Model 200 Controller supports communications with the 2.4 GHz
network across the Ethernet network. When you install and configure the
controller, you identify the host computer(s) and TRAKKER 2425 terminals
in your network. The terminals communicate through the controller with
your host computer. For help installing the controller, see the Model 200
Controller System Manual (Part No. 063439).
To have the T2425 terminal communicate with the controller, you must
configure these parameters on the controller:
• Configure the UDP (User Datagram Protocol) Plus network.
• Assign an IP address to each TRAKKER 2425 terminal.
• Enable all T2425 terminals.
• Define the host environment parameters, which includes configuring for
terminal emulation or screen mapping.
• Define the host communications parameters, which includes the physical
connection (network adapter cards) to the host computer.
To use the screen mapping application on the T2425 terminal, you must also
configure the following:
• Create the script file using the Script Builder tool on the controller.
• Generate the template to download to the T2425 terminal.
Configuring the 0100 Access Point
The 0100 Access Point acts as a wireless bridge to provide RF communications
between the TRAKKER 2425 terminal and the Model 200 Controller. For help,
see the 0100 Access Point User’s Manual (Part No. 062367).
Note: All access points that the TRAKKER 2425 terminal may communicate with
and roam between must be in the same IP subnetwork.
To have the T2425 terminal communicate with the access point, you must
know the value of these parameters on the access point:
• RF domain
• RF security identification (ID) (optional)
4-7