Download INSTRUCTION MANUAL
Transcript
How to measure period 1. Connect the test leads to the terminals on the front panel as shown in Figure 2-7. 2. Set RESOLUTION (refer to 3.1.3 Resolution & NPLC Setting) or skip this step to use the default setting. 3. Press FREQ button for frequency measurement, and then press CONFIG button. 4. use ◁ and ▷ buttons to locate “PERIOD”. Press ENTER to switch the frequency measurement to period measurement. 5. Select the auto-range function by pressing AUTO button on the front panel or use △ and ▽ buttons to manually select the desired range. 6. Connect test leads to your source signal and observe readings shown on the display. If the input signal voltage is beyond the allowed range, an overflow message “VAC OVLD” will be displayed. Figure 2-7 26