Download Operator`s Manual

Page 5
To Order Call: 1-877-XVARMIT
Component Unit Operating Instructions
Please read carefully before use!!
1. Secure oxygen & propane tanks to pickup, trailer, 4-wheeler, or
hand cart.
2. Attach regulators on oxygen & propane tanks.
3. Place VG system on ground, pickup tailgate, trailer, 4-wheeler,
or hand cart.
4. Place fire extinguisher (not included) within easy reach.
5. Connect twin hose to tank & VG System(Red to Propane Flash
Arrestor, Green to Oxygen Flash Arrestor).
6. Connect single hose from VG System to VG Applicator.
7. Connect XLR cord from VG Applicator to yellow ignition box. A 9
volt battery must be inserted in the yellow box. ONCE BATTERY IS
CONNECTED DO NOT PUSH THE BUTTON UNLESS READY TO IGNITE. THERE IS NO KILLSWITCH.
8. Place the flex igniter into the tunnel system.
9. Place sand bags over burrow leaving a small opening on the side
of sand bag for gas bar nozzle.
10. Inject gas mixture in to tunnel system for recommended
amount of time. Time will depend on type of animal. See page 7
and/or inside lid of control box for animal types.
11. Pull gas bar out of tunnel seal opening where nozzle had been,
leaving flex igniter wand in tunnel system and sand bags. Walk to
a safe distance with gas bar in hand and press the ignition button.
GAS BAR SHOULD NEVER BE LEFT IN TUNNEL SYSTEM
WHEN GAS IS IGNITED!
THIS COULD CAUSE SERIOUS INJURY!!!