Download My IC Phone User Manual - Alcatel
Transcript
OpenTouch™ Session Border Controller User’s Manual 6. As the 'Test Call ID' parameter is set to "101", the device identifies the incoming call as a test call and sends it directly to the simulated test endpoint "101". To configure SBC call testing: 1. Configure the test call parameters (for a full description, see ''SIP Test Call Parameters'' on page 399): a. Open the Test Call Settings page (Configuration tab > System menu > Test Call > Test Call Settings). Figure 155: Test Call Settings Page b. c. d. 2. 39.6 In the 'Test Call ID' field, enter a prefix number for the simulated test endpoint on the device. In the 'SBC Test ID' field, enter a called prefix number for identifying the call as an SBC test call. Click Submit. Configure regular SBC call processing rules for called number prefix "101", such as classification and IP-to-IP routing through a proxy server. Test Call Configuration Examples Below are a few examples of test call configurations. Single Test Call Scenario: This example describes the configuration of a simple test call scenario that includes a single test call between a simulated test endpoint on the device and a remote endpoint. Figure 156: Single Test Call Example Test Call table configuration: Endpoint URI: "101" Called URI: "201" Route By: Dest Address 8AL90068USAAed01 375 /462
Related documents
Alcatel-Lucent OpenTouch™ Session Border Controller User
User`s Manual
Audiocodes Mediant 2000 SIP User Guide
User`s Manual
Release Notes - NFS Professional Services
LTRT-65606 MediaPack & Mediant 1000 SIP Analog
Alcatel-Lucent OpenTouch™ Session Border Controler – R2.x
PDF Learn how to use TeamShare? TeamShare User Manual
User`s Manual
8082 My IC Phone Release Note
SIP User`s Manual
Release Notes Version 5.0