Download User manuals

Remote Control
RIGOL
non-zero span.
358
Invalid mark readout.
When the marker is in Delta Pair mode, the marker readout in 1/Δ Time
is of no effect; and when the marker is in normal mode, MkrΔ ->CF and
MkrΔ ->Span are of no effect.
359
Invalid function when trace is not enabled.
To point a marker to a trace is not available when the correct trace
function is not enabled.
User preset failed.
The User preset has failed because the edition of the saved status data
is incorrect or has been damaged. In this situation, the system will
execute Factory settings as the defaults.
Input signal power out of range.
Indicate that the input signal power is out of range, if this state
continues for a long time, some damage may occur to the device.
Please reduce the input power.
1st LO unlock.
The first LO unlock. Please report the error to your RIGOL sales or
technical support.
2nd LO unlock.
The second LO unlock. Please report the error to your RIGOL sales or
technical support.
Track LO unlock.
Track LO unlock. Please report the error to your RIGOL sales or
technical support.
Probe power short-circuit.
Please check the Probe power short-circuit as well as its connection
state.
Option not installed.
The desired operation cannot be performed because a required option
is not installed. For example, pressing Source with no tracking
generator installed.
No peak found.
No signal peak was found that meets the criteria under Peak Search.
No fundamental wave found.
Indicates that no fundamental wave greater than 50dBm is found.
No two-tune signal found.
Invalid function as cursor is not enabled.
360
400
401
402
403
410
420
460
461
462
463
User’s Guide for DSA1000 Series
5-17