Download User manuals

Front Panel Key Reference
RIGOL
9.
Pass/Fail
Compares the measured curve with the pre-edited, if the related rules are met,
the result will be “Pass”, or else is “Fail”.
Select the power type to Pass/Fail and press Meas Setup to set corresponding
parameters.
2.4.1.2 Restart
Re-executes the active or suspended measurement.
2.4.1.3 Pause
Suspends the measurement after current measurement. However, the sweep is
continuous when pressed, an icon
measurement data stops updating.
is shown on the results window, and the
2.4.1.4 Resume
Restarts the suspended measurement. An icon
the measurement data begins updating again.
is shown at the result window, and
2.4.1.5 Meas Mode
Sets the measurement mode to Single or Continuous. In single mode, the analyzer
stops after a specified number of measurements. After this, every time you press
Single, measurements will be executed a specified number of times and new data
will be replaced. In Continuous mode, the analyzer measures continuously.
2-46
User’s Guide for DSA1000 Series