Download User Manual - EndRun Technologies

ENDRUN
gpsdynmode
gpsrefpos
gpsstat
gpstrkstat
gpsversion
ntpconfig
setgpsdynmode
setgpsrefpos
updatelilo
TECHNOLOGIES
Prints the GPS dynamic mode currently in effect to the
console.
Prints the GPS reference position to the console.
Prints the GPS sub-system status information to the
console.
Prints the GPS satellite tracking status to the console.
Prints the GPS firmware and FPGA version information to
the console.
Interactive shell script that guides the user in configuring
the Præcis Gntp NTP sub-system. Allows configuration
of MD5 authentication and broadcast/multicast mode. All
parameters are retained in non-volatile FLASH disk storage.
Allows the user to set the dynamic mode of operation of the
GPS sub-system. It may be ON or OFF.
Interactive shell script that prompts the user for an accurate
reference position, performs syntax and argument validity
checking then passes the position to the GPS sub-system.
Shell script that must be run to update the Linux Loader
(LILO) so that it will boot a new root file system image.
gntpenableupgrade must have been previously executed
in order to run this command.
Detailed Command Descriptions
accessconfig
This command starts an interactive shell script that will allow the root user to configure
limitation of telnet, ssh and snmp access to the Præcis Gntp. By default, the unit is
configured to allow access by all users. If you need to limit telnet, ssh or snmp access,
e.g. for security reasons, you must run this script as root from either the RS-232 serial I/O
port or from a telnet or ssh session.
This script modifies these files: /etc/hosts.allow and /etc/hosts.deny. These are non-volatilely stored in the FLASH disk /boot/etc directory. You must re-boot the Præcis Gntp
after running this script for the changes to take effect.
Usage:
Set:
Præcis Gntp response:
accessconfig
interactive shell script is started
37
Præcis Gntp User’s Manual