Download Part No - AmetekTest

LIST OF ICONS USED IN THIS MANUAL
WARNING
The raised hand icon warns of a situation or condition that may lead to personal injury
or death. Do not proceed until the warning is read and thoroughly understood.
Warning messages are shown in bold type.
DANGEROUS VOLTAGE
The lightning icon warns of the presence of an uninsulated dangerous voltage within
the product enclosure that might be of sufficient magnitude to cause serious shocks
or death. Never open the enclosures unless you are an authorized and qualified
CHATILLON service personnel. Never open any enclosure when power is
connected to the system or its components.
CAUTION
The exclamation point icon indicates a situation or condition that may lead to
equipment malfunction or damage. Do not proceed until the caution message is
read and thoroughly understood. Caution messages are shown in bold type.
NOTE
The note icon indicates additional or supplementary information about the action,
activity or concept. Notes are shown in bold type.
GENERAL SAFETY
Read this manual completely before
attempting to use the CS series force
tester. By following the instructions
contained in this manual, the optimum
safety, accuracy and performance can
be attained.
The CS series force tester has a moving
crosshead! Exercise extreme caution
during testing or whenever the crosshead is
moving. Never place fingers inside the
column.
Never operate the CS series force tester
with the lower cover removed.
Position the CS series force tester so
that it is easy to access the mains power
switch and mains power cord.
Use an industrial-quality Power Surge
Suppressor with your CS System.
Never use the CS series force tester in a
manner not specified by AMETEK.
Always make sure that the supply
power matches the setting on the
Power Input Module BEFORE turning
power ON. Failure to do so may cause
serious damage to the tester.
Obey all warning labels on your CS
series force tester.
The CS series force tester has a
switchable mains input and may operate
with 110V or 230V provided the Power
Input Module is in the proper setting
corresponding to the source power.
The equipment is a Class 1 product
which must be connected to a mains
socket outlet with a protective earth
connection.
General safety precautions must be
followed when using this CHATILLON
product. Failure to observe precautions and
warnings may result in damage to the
equipment, or injury to personnel.
It is understood that safety rules within
companies vary. If a conflict exists between
the material contained in all CHATILLON
User’s Guides and the rules of a company
using a CHATILLON product, the more
stringent rules should take precedence.
CS User Manual 3