Download 33164422 - heidenhain

8.2 Drilling Cycles
BORE MILLING (Cycle 208)
1 The TNC positions the tool in the tool axis at rapid traverse FMAX
to the programmed set-up clearance above the workpiece
surface and then moves the tool to the bore hole circumference
on a rounded arc (if enough space is available).
2 The tool drills in a helix from the current position to the first
plunging depth at the programmed feed rate F.
3 When the drilling depth is reached, the TNC once again traverses
a full circle to remove the material remaining after the initial
plunge
4 The TNC then positions the tool at the center of the hole again
5 Finally the TNC returns to the setup clearance at FMAX. If you
have entered a 2nd set-up clearance, the tool subsequently
moves to that position in FMAX.
Before programming, note the following:
Program a positioning block for the starting point (hole
center) in the working plane with RADIUS
COMPENSATION R0.
The algebraic sign for the cycle parameter TOTAL HOLE
DEPTH determines the working direction.
If you have entered the bore hole diameter to be the
same as the tool diameter, the TNC will bore directly to
the entered depth without any helical interpolation.
HEIDENHAIN TNC 426, TNC 430
Kkap8.pm6
175
175
28.06.2006, 11:35