Download User Manual

Transcript
Access Control
MAC-based ACLs
28
Creating ACLs Workflow
To create ACLs and associate them with an interface, perform the following:
1. Create one or more of the following types of ACLs:
a. MAC-based ACL by using the MAC Based ACL page and the MAC Based ACE page
b. IP-based ACL by using the IPv4 Based ACL page and the IPv4 Based ACE page
c. IPv6-based ACL by using the IPv6 Based ACL page and the IPv6 Based ACE page
2. Associate the ACL with interfaces by using the ACL Binding page.
Modifying ACLs Workflow
An ACL can only be modified if it is not in use. The following describes the process of unbinding an ACL in
order to modify it:
1. If the ACL does not belong to a QoS Advanced Mode class map, but it has been associated with an
interface, unbind it from the interface using the ACL Binding page.
2. If the ACL is part of the class map and not bound to an interface, then it can be modified.
3. If the ACL is part of a class map contained in a policy bound to an interface, you must perform the chain
of unbinding as follows:
•
Unbind the policy containing the class map from the interface by using Policy Binding.
•
Delete the class map containing the ACL from the policy using the Configuring a Policy (Edit).
•
Delete the class map containing the ACL, by using Defining Class Mapping.
Only then can the ACL be modified, as described in this section.
MAC-based ACLs
MAC-based ACLs are used to filter traffic based on Layer 2 fields. MAC-based ACLs check all frames for a
match.
MAC-based ACLs are defined in the MAC Based ACL page. The rules are defined in the MAC Based ACE
page.
Cisco Small Business 500 Series Stackable Managed Switch Administration Guide
520