Download User manual

4. Installation Instructions
Unpack the unit and make sure that the grounded power supply cord is suitable for your
country. The light generator is prepared for universal power input, capable of running from 100240 V (nominal) 50 or 60 Hz.
1. Fully insert the fibre harness
common end into the light.
port of the light generator.
2.Tighten the grille screw with
the supplied Allen key.
3. Connect the power cord at
the back of the light source.
NOTE!
Before switching on, make sure that the requirements in the installation instructions are
observed.
Place the light generator:
Do not place the light generator
Too close to a wall. The light
generator has too get rid of the
heat from the lamp.
Do not place the front of the light
generator too close to a wall.
Always place the light
generator on the feet.
Do not place the light generators
on top of each other.
The heat cannot come from
the light from generator.
Make sure that hot air from one light generator
does not blow directly into the air intake of the
light generator next to it.
4