Download User Manual

NEOX™ Tilt-in-Space
ENGLISH
14.3 Turning the anti-tippers
Turn anti-tippers inwards towards the frame when being pushed by an
attendant or overcoming obstacles such as climbing curbs.
1.Press the rear anti-tipper release pin A on the anti-tipper tube so that both release pins are drawn inside.
2. Hold pin and turn anti-tipper inwards towards the frame
3. Repeat with second anti-tipper
4. Ensure to return anti-tip tubes to initial position once maneuver is complete.
Figure 59 : Anti-Tip Tubes
Make sure the anti-tippers are fully engaged and release buttons fully
potruding out of adjustment holes. Anti-tippers must always be used.
When outdoors on wet, soft ground or on gravel surfaces, anti tippers may
not provide the same level of protection against tip over. Ensure both antitippers are adjusted to the same mounting hole.
Always verify if the anti-tippers are at the proper height after making any
adjustment or modification to the wheelchair in order to ensure the safety
of the user.
For maximum safety, the distance between the ground and the anti-tipper
must not exceed 2".
The anti-tippers are not to be used as tipping levers.
44