Download Manual

450
4 USING THE FIREWOOD PROCESSOR,
OPERATION
4.1 Operating controls, Fig. 4.1 and 4.2
1
2
3
4
5
6
7
8
9
4.1
A
1.
2.
3.
4.
5.
6.
7.
8.
9.
A.
Release lever for the splitting area covers
Turning to the side and height adjustment of the discharge conveyor
Stopping and speed adjustment of the discharge conveyor belt
Adjusting the splitting wedge height
Adjusting the lowering speed of the saw-bar
Launch lever for the splitting (start/reverse)
Lifting the in-feed roller of the log clamp
Control lever for the in-feed conveyor and the sawing (8.1-8.3)
Control of the hydraulic out-take (log-deck)
Control switch for electric operation (emergency stop, start)
8.1 Advancing the in-feed conveyor
8.2 Reversing of the infeed
conveyor
8.3 Sawing
When the lever is pulled, the saw
starts up and begins to lower.
When the lever is released, the
saw returns to its upper position
and stops.
4.2
19