Download CNT-90 Series User`s Manual

Transcript
Using the Controls
have selected Frequency, you can then select
between Frequency, Frequency Ratio and
Frequency Burst. Finally you have to decide
which input channel(s) to use.
Autoset/Preset
By depressing this key once after selecting the
wanted measurement function and input channel, you will most probably get a measurement result. The AUTOSET system ensures
that the trigger levels are set optimally for
each combination of measurement function
and input signal amplitude, provided relatively normal signal waveforms are applied. If
Manual Trigger has been selected before
pressing the AUTOSET key, the system will
make the necessary adjustments once
(Auto Once) and then return to its inactive
condition.
AUTOSET performs the following functions:
•
•
•
•
Set automatic trigger levels
Switch attenuators to 1x
Turn on the display
Set Auto Trig Low Freq to
«
«
«
100 Hz, if fin ³100 Hz, or to
fin, if 10<fin<100 Hz, or to
10 Hz, if fin £10 Hz
A higher value means faster settling time.
By depressing this key twice within two seconds, you will enter the Preset mode, and a
more extensive automatic setting will take
place. In addition to the functions above, the
following functions will be performed:
•
•
•
•
•
•
Set Meas Time to 200 ms
Switch off Hold-Off
Set HOLD/RUN to RUN
Switch off MATH/LIM
•
Switch off Arming
n Default Settings
An even more comprehensive preset function
can be performed by recalling the factory default settings. See page 2-15.
Move Cursor
There are four arrow keys for moving the cursor, normally marked by text inversion,
around the menu trees in two dimensions.
Display Contrast
When no cursor is visible (no active menu selected), the UP/DOWN arrows are used for
adjusting the LCD display contrast ratio.
Enter
The key marked ENTER enables you to confirm a choice without leaving your menu position.
Save & Exit
This hard key is marked EXIT/OK. You will
confirm your selection by depressing it, and at
the same time you will leave the current menu
level for the next higher level.
Don't Save & Exit
This hard key is marked CANCEL. By depressing it you will enter the preceding menu
level without confirming any selections made
at the current level.
If the instrument is in REMOTE mode, this
key is used for returning to LOCAL mode,
unless LOCAL LOCKOUT has been programmed.
Switch off Analog and Digital Filters
Set Timebase Ref to Auto
Description of Keys 2-7