Download GPS/GSM/GPRS TRACKER USER MANUAL

GPS / GSM / GPRS TRACKER
(Before setting the authorized number, all the numbers can get reply from the tracker by
calling or SMS command; after setting, only the authorized number own the rights.
If an un-authorized number call the unit, there will be no response from the tracker.
If an un-authorized number know the password, then it can set the tracker. Since it can't
set the authorized number, but it can send "begin123456" to initialize the tracker, then all
authorized number will be removed. So take care of your password.)
5.5 REAL-TIME POLLING
When an authorized number call the tracker (suppose there're authorized number), the
tracker will hang up the call and reply a message with real-time geo-info.
5.6 AUTO TRACK
Do following settings, then tracker will send geo-info to you for certain times with certain
interval. For example "t030s005n123456" means sending total 5 messages with the
interval 30 seconds.
(s: second, m: minute, h: hour, and the maximum value of the 3 digits is 255)
For heaps of geo-info messages, use command as "t030s***n123456".
5.7 VOICE SURVEILLANCE (two-way communication)
 Send SMS command "monitor+password" to switch to the voice surveillance mode, for
example "monitor123456". You will receive reply as "monitor ok!" if the setting is
successful. Under this mode, when you call the tracker, the tracker will pick up the call,
then you can communicate with with the tracker.
 Send SMS command "tracker+password" to switch back to default mode. You will
receive reply as "tracker ok!" if the setting is successful.
5.8 SOS
Press the SOS button for 3 seconds, it will send "help me! + Geo-info" to all the authorized
number. The alarm system can be chosen,
 Keep sending the alarm once every 3 minutes until get reply from the authorized.
 Send only once.
5.9 GEO-FENCE
Send SMS command "stockade+password+space+long1,lat1;long2,lat2" to define a
restricted area. When the tracker moves out of the area, there will be the alarm as
"stockade! + Geo-info".
The command is as , "stockade123456 113.000000e,22.700000n;113.200000e,22.500000n".
Point one with the
coordinates: long1, lat1
Point two with the
coordinates: long2, lat2
(BACK TO TOP)
6