Download SafEty and Risk Evaluation using bayesian NEts

Transcript
SERENE Method Manual
Version 1.0 (F) May 1999
We want this node to take on values 0,1,…,10. For reasons that will be explained below, we need to
make the node type continuous rather than discrete. To get the appropriate state values click on the
“States” tab and use the “Add Sequence” button as before to create the states as shown:
It is important to note at this point that the states here are NOT 0,1,2,…,10, but rather the 10 intervals:
]0,1], ]1,2], …, ]9,10].
The actual values for this node can be though of as a 10 point scale for testing accuracy where 0
means totally inaccurate and 10 means perfectly accurate.
Next we need to define the NPT for the node “discovered defects”. Select the Properties window for
this node and select “Distribution Function”.
SERENE 22187 ESPRIT Framework IV Information Technology Programme Task 1.7
Page 94 of 200