Download PICED Programmer`s Guide

Home Management Series
PICED Programmer's Guide
CNI Properties
CNI IP Address - this is the IP Address of the CNI used by the Wiser Home Control. By default it
is one greater than the Wiser Home Control IP Address.
CNI Port - this is the port number used by the CNI
The Wiser Home Control must be on the same subnet as the PC in order to be able to transfer the
project. The Wiser Home Control and CNI must also be on the same subnet as each other. See
http://en.wikipedia.org/wiki/Subnetwork for an explanation of network masks and subnets.
Access
This controls whether the following Wiser features are to be allowed to be accessed by a user:
Enable ToolKit Control - allows the Wiser Home Control's CNI to be connected to remotely
using the C-Bus ToolKit or other programs via the Wide Area Network (WAN) side of the Wiser
Home Control (ie. via the Internet)
Enable Projector Control - this enables a Flash Projector, PC and mobile clients to control the
Wiser Home Control via the WAN
URL/IP Address - specify the URL or IP address in order to access the Wiser unit over the
internet for remote project/firmware trasnfer
Remote Port - specify the port number in order to access the Wiser unit over the internet
Enable Project Update - this allows PICED to transfer a new project to the unit via the WAN.
Enter the URL/IP Address for the Wiser Home Control at the remote site. The Port is fixed at
8336.
Options
Language - select the language to be displayed on the Wiser User Interface
Use NTP to Maintain Time - use the NTP time service to set the Wiser Home Control time
Show Full Screen - select this if you want the Flash Projector to show full-screen.
© Copyright 2014 Schneider Electric (Australia)
Page 67