Download Winleads™ Auto Dialer Software User Manual

3.0 - Installing the Dialogic Board(s)
Read this entire section before proceeding with the install.
Install Dialogic board(s) into computer. For multiple boards install them in the order of the offset address.
NOTE: IF YOU ARE INSTALLING SC BUS TYPE BOARDS ( D41ESC) THERE ARE NO JUMPERS OR
SWITCHES TO SET. YOU ONLY NEED TO SET THE BOARD ID NUMBER ON EACH BOARD YOU
INSTALL. IT IS THE ROTARY SWITCH FOUND ON THE EDGE OF EACH BOARD. IF YOU ARE
INSTALLING ONLY 1 BOARD SET IT TO “0”, IF YOU ARE INSTALLING MULTIPLE BOARDS SET
THEM TO “0,1,2,etc..” And install the ribbon cable across the top of the boards in a multi board install. If
you are installing a single board there will be no ribbon cable and you need to change the “Bus Type” to none
in the Dialogic Config Manager.
3.1 - Proper Precautions When Installing Dialogic Board(s)
Install the Dialogic Board(s) in a static-safe work area. See Figure 2.2.32.
Figure 2.2.32
263