Download MX100E User Manual

User Manual
MX100E SIP-ISDN Gateway Series
Table 5-22 ISDN Status Parameters
Name
Description
ISDN Group ID
The ID of an ISDN group.
state
State.

IS indicates the in-service state.

OOS indicates the out-of-service state.

MOOS indicates the manually taken-out-of service state, i.e. the backup signaling channel
is disabled.
Int Id
The ID of an interface card, which is 0.
side
Two sides of the ISDN: user and network side, which must be set in pairs, with one side being
User and the other side being Network.
echo
The echo cancellation function.
On: indicates that the echo cancellation is enabled.
Off: indicates that the echo cancellation is disabled.
hunting
Two search modes of idle timeslot:

FORWARD

BACKWARD
DS1
The type of an interface card: T1 or E1. The connection state of the interface card can be:

UP

DOWN
slot/ds1/ds0
One of interfaces (represented by ds1) on a certain slot (represented by slot) into which the T1
or E1 interface card is inserted. ds0 specifies a signaling channel. The signaling channel for the
E1 card is 16 timeslots and the signaling channel for the T1 card is 24 timeslots.
Equipped MAP
The available state of the remaining 30 timeslots on the E1 card, except timeslots 0 and 16. If
the binary value in 0xfffefffe is 1, the timeslot is available.
Free MAP
The state of an idle timeslot.
LineType
The frame format, including SF, D4, T1_UNFRAMED, SF, E1, E1_MF, E1_CRC and
E1_UNFRAMED.
LineCode
The line code, including B8ZS, AMI, JBZS, HDB3, ZBTSI, B6ZS, JBZS, etc.
LineBuildOut
The line build-out, which is 120 or 75 Ohm.
ClockTiming
The clock source: Local or Through.
Payload
The PCM encoding type: ALAW or ULAW.
5.7.4 System Startup
Click Logs > System Startup tab to open this interface. The gateway boot up information is available in
this page, including the hardware configuration.
5-32
www.newrocktech.com