Download GST Professional - Tooled

OBJ_BUCH-624-003.book Page 21 Tuesday, October 20, 2009 11:37 AM
English | 21
ning but not actually doing the job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical Data” is
in conformity with the following standards or
standardization documents: EN 60745 according to the provisions of the directives
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
The battery is equipped with a NTC temperature
control which allows charging only within a temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this manner.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Replacing/Inserting the Saw Blade
f When mounting the saw blade, wear protective gloves. Danger of injury when touching
the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of these instructions. Use
only T-shank saw blades. The saw blade should
not be longer than required for the intended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A)
Insert the saw blade 12 (teeth in cutting direction) into the stroke rod until it latches 9.
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
05.10.2009
While inserting the saw blade, pay attention that
the back of the saw blade is positioned in the
groove of the guide roller 10.
Assembly
f Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
during transport and storage, remove the
battery from the power tool. There is danger
of injury when unintentionally actuating the
On/Off switch.
Battery Charging
A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approx. 5 charging/discharging cycles.
To remove the battery 3 press the unlocking buttons 4 and pull out the battery downwards. Do
not exert any force.
Bosch Power Tools
9
10
Note: If the grooves of the saw blade holder are
not in the position shown in the figure, then the
saw blade 12 cannot be inserted into the stroke
rod 9. Briefly press the SDS clamping lever 8 toward the side and release it again.
f Check the tight seating of the saw blade. A
loose saw blade can fall out and lead to injuries.
2 609 932 701 | (20.10.09)