Download USER MANUAL

Care and Maintenance - Lamp and Acrylic Replacement
Opening/Replacing Bench Acrylic
The Bench acrylic also does not need to
be removed to perform normal maintenance, such as cleaning and replacing
lamps. Turn the quarter-turn latches on
either side of the acrylic and lift the front
edge. Two gas springs hold it open.
A secondary acrylic rests below the main
acrylic. Simply lift the secondary acrylic
out to access the lamps.
To remove the Bench acrylic, lift the
acrylic so the gas springs are fully extended. Each gas spring is held to the acrylic
bracket with a locking pin. Unclip the pin
and slide it out to disconnect the spring
from the acrylic (see top right). Inside the
Bench, at the back corners of the acrylic,
are two keeper brackets (see bottom
right). Swing the bracket up to free the
Bench acrylic hinge. Raise the acrylic and
lift it, along with the hinge channel, from
the Bench. Replace the acrylic by setting
the hinge channel in its slot at the rear of
the Bench. Swing the keeper brackets
down, and reconnect the gas springs.
2. PULL OUT
1. FLIP UP
KEEPER BRACKET
26732-01A
13