Download HRU Technical Brochure

Transcript
Electrical connection
shows the direction and source
Connect the HRU ECO 4 to a
of the air.
• the outside temperature
exceeds 19° C for an extended
period – dependent upon exact
230V 50Hz power supply. A flying
lead is attached to the unit using
Counter flow heat exchanger
a 3amp fuse as standard. A
The HRU ECO 4’s heat exchanger
double pole isolation switch with
comprises triangular canals
a minimum contact gap of 3mm
through which incoming and
must be fitted. The unit is double
outgoing air flows. Each canal is
insulated so does not need to be
surrounded by canals with air
earthed. As standard, the
flowing in the opposite direction,
electrical connection on the unit
creating a huge surface area for
is positioned on the left hand
heat exchange.
temperature.
Frost protection device
The frost protection device,
which protects the unit from
freezing in low temperatures,
works as follows:
with the valve open the HRU ECO
4 mixes internal air with fresh,
incoming air at the same time
side. When the unit is
the supply fan increases speed
reconfigured for
to maintain fresh air volumes
mirrored/handed installation this
as the temperature drops, fan
connection will be positioned on
speed decreases until a
the right hand side.
minimum is reached.
Meanwhile, the exhaust fan
Motors
speed increases
The HRU ECO 4 features two
in extreme low temperatures the
energy efficient DC motors.
Backward curved blades on the
Removing the Heat Exchanger
frost protection device closes.
impellors maximise air supply
and extraction rates and help
keep the unit clean.
supply fan switches off and the
100% summer bypass valve
The exhaust fan, however,
The HRU ECO 4’s automatic
continues to operate
temperature controller will open
Exhaust and supply connections
the bypass valve when:
After approximately 90 minutes,
Diameters of all exhaust and
• the inside temperature is
the air supply fan restarts at low
supply connections are 150 mm
higher than required (not
speed and the frost protection
(internal) and 180 mm (external)
adjustable).
valve opens to reassess the risk
• the inside temperature is
of freezing. As the temperature
accessories. An embossed
higher than the outside
rises, the reverse of the above
indicator on every connection
temperature.
process begins.
for the attachment of modular
4