1
Download user Manual
Transcript
IRE GB First use Mounting the table extensions 1. Screw the table width extensions 2 and table length extension 3 loosely onto the saw table 1 with two Allen head screws 25 and washers 27 each. 7 3 1 8 2 25 26 2. Screw the 36.5 cm table supports 8 loosely onto the sides of the saw table using two hexagon screws 24 and washers 27 each. 3. Screw the other end of the table supports loosely onto the table width extensions 2 using two hexagon screws 24 , washers 27 and nuts 26 . 4. Screw the 48 cm table supports 7 loosely onto the back end of the saw table using two hexagon screws 24 and washers 27 each. 5. Screw the other end of the table supports loosely onto the table length extension 3 using two hexagon screws 24 , washers 27 and nuts 26 each. 6. Align the table width and length extensions so that they are level with the saw table and tighten all screws. 7. Carefully turn the table saw over and set it upright with its legs on the ground. After Sales Support GB 0044 151 649 1500 IRE 0044 1890 946 244 21 [email protected]
