Download CMTS User Manual

Parameter:
Full path:
Description:
Syntax:
Commands:
Example 1:
Output 1:
Parameter:
Full path:
Description:
Syntax:
Commands:
Example 1:
Output 1:
Parameter:
Full path:
Description:
set-all
root/cable/modulation/set-all
This command is used to set the profile related to each Interval
Usage Code (IUC) for a specified modulation profile. Errors or
incompatible configurations in the profile(s) cause modems to
drop connectivity, drop short or long data packets, or fail to
connect to the network. You cannot use the set-all command if
the modulation profile is used by an active upstream channel.
You must create a new modulation with the add command or
set the admin-status of the upstream channels that use this
profile to down.
set-all mp5 3 (1st number is Profile, 2nd number is IUC)
- Value – mp1 through mp8 profiles are available. IUC values
are mp1, mp2, mp3, mp4, mp5, mp6, mp7, mp8.
set-all mp5 3
set-all mp5 3
control = 1 ->
modulation-type = 3 ->
preamble-len = 128 ->
differential-encoding = 2 ->
fec-error-correction = 5 ->
fec-codeword-length = 34 ->
scrambler-seed = 338 ->
max-burst-size = 0 ->
last-codeword-shortened = 2 ->
scrambler = 1 ->
del
root/cable/modulation/del
This command is used to delete a modulation profile.
del mp1-mp8
- Value – mp1 through mp8 profiles are available.
del mp 5
show mp5
(no output will be shown, it is deleted)
Commands:
Example 1:
Output 1:
index
root/cable/modulation/index
This displays the index of the modulation profile. This is a
display only.
N/A
- Value N/A.
show or show mp1 – mp8
show
See show command previously displayed.
Parameter:
Full path:
iuc
root/cable/modulation/iuc
Syntax:
CMTS User Manual
80
Version: 3.0.33