Download Instruction Manual

Front Panel - DIY or Perspex
Like the Raspberry Pi, the Seven Segments of Pi is supplied without a case but you can either make your
own Front Panel or buy the Seven Segments of Pi Perspex Front Panel Kit.
DIY Front Panel
To make your own Front Panel use stout cardboard
or similar material cut to the dimensions shown
below and decorate it with your own design!
Perspex Front Panel
The Seven Segments of Pi Perspex Front Panel Kit
is supplied complete with all screws, nuts, washers
and spacers to attach it to you Seven Segments of Pi.
T.B.A
Acknowledgements
To fix your DIY Front Panel to the Seven Segments
of Pi you will need the following:• 4 x M3x16mm Panel Head Screws
• 4 x M3 Nuts
• 4 x M3 Washers
• 4 x M3x10mm Spacers
Instruction Manual Updates
Whilst every effort has been made to ensure these
instructions are comprehensive and accurate it is
possible there may be errors or omissions. Please let
us know of any such errors or omissions via the web
site www.SevenSegmentsOfPi.com.
Your help in doing so is very much appreciated!
We will publish on the web site any corrections or
updates as we become aware of them.
I would like to express my gratitude to everyone
who has contributed to the Seven Segments of Pi.
In particular I would like to thank:Advanced Layout Solutions, Berkshire UK, for the
Printed Circuit Board Layout.
Merlin Circuits, Deeside UK, for the Prototype
Printed Circuit Boards.
Pupils and Teachers of Kennet School, Thatcham,
UK, for helping develop the software challenges and
‘test driving’ the prototype kits.
Matt Hunt and Paul Blenkhorn for the graphics.
Alastair Bryers for help with Linux, Raspbian and
NOOBS.
Raspberry Pi® and Logo are trademarks of the
Raspberry Pi Foundation
Python and Logo are trademarks of the Python
Software Foundation
35