Download User Manual

Transcript
4.4 Wireless – Basic Wireless Settings
Wireless Network
Wireless Settings
If you are using a Wireless-B, Wireless-G, Wireless-N, Wireless B+G, or Wireless BGN network
then the following settings that you may need to configure.
Wireless: You can enable or disable the wireless function.
Network Mode: From this drop-down menu, you can select the wireless standards running on your
network. If you have both 802.11g and 802.11b devices in your network, keep the default setting,
B/G Mixed. If you have only 802.11g devices, select Wireless-G Only. If you have only 802.11b
devices, select Wireless-B Only. If you have only 802.11n devices, select Wireless-N Only. If you
have both 802.11n and 802.11g and 802.11b devices in your network, select Wireless-BGN. If you
do not have any 802.11g and 802.11b devices in your network, select Disabled.
Network Name (SSID): The service set identifier ( SSID ) or network name. It is case sensitive and
must not exceed 32 characters, which may be any keyboard character. You shall have selected the
same SSID for all the APs that will be communicating with mobile wireless stations.
Radio Band: This argument is related to the bandwidth. 20MHz Channel could reach 150 Mbps,
and 40 MHz could reach 300 Mbps.
Channel: Select the appropriate channel from the list provided to correspond with your network
settings. All devices in your wireless network must broadcast on the same channel in order to
communicate.
Ext Channel: When 40MHz has been selected with Band Width, two channels of Control Channel
and Extension Channel are used.
SSID Broadcast: When wireless clients survey the local area for wireless networks to associate
with, they will detect the SSID broadcast by the Router. To broadcast the Router's SSID, keep the
default setting, Enabled. If you do not want to broadcast the Router's SSID, then select Disabled.
WPS: WPS function is an easy-to-use encryption to keep wireless connection safe and the default
setting, Enabled, is to enable it. If you do not want to enable the WPS function, then select
Disabled.
PIN Code of client: Type the client’s PIN code here then click “Connect” button then you could
start WPS connection
.
User’s Guide
17