Download Instruction Manual

Transcript
11.3.1. Models with flat burrs (K3, K6 and K8)
Position the regulator collar ( ) leaving about 45º between the grind point lock
screw ( ) and regulator limit stop (Fig. 13). In that position, tighten the regulator
( ) on the upper burr carrier and with an Allen key A3 series for the K3 (Fig. 9), or
a T20 Torx screwdriver for the other models, as Fig. 10.
K01068 | v. 17/11/2015 | Ref. quality process 002/03 | ORIGINAL INSTRUCTIONS
19