Download User Manual

;AD7!===IgYfAUbiU`
To store the status selected between On and Off, press the
If you press the
[ENT]key.
[MENU] key while changing the values on the setting menu, all
the values that has been changed are canceled and it is changed into Display Mode.
To move to the next menu on Display Mode, press the
[MENU]key.
8.2.7 I-NET ADDRESS DISPLAY
The front window displays an I-Net address of GMPC.
Pressing the
[SEL]key once, it is changed from Display Mode to Setting Mode
and the value on the display window goes on and off. To increase this value press
the
[SEL]key.
Reaching the value you wish to change, press
the
[ENT]key to store it and then
window is changed into Display Mode automatically.
If you press the
[MENU] key while changing the values on the setting menu, all
the values that has been changed are canceled and it is changed into Display Mode.
To move to the next menu on Display Mode, press the
[MENU]key.
8.2.8 Selecting a Protocol
Either MODBUS or I-Net protocol is selected in this menu by means of the one
adopted on the SCADA system.
To move to the menu selecting a protocol, press
pressing the
[MENU]key. And each time
[SEL] key, it displays GPMC or MODBUS on the window one by
one.
To store the one selected between GMPC and MODBUS, press the
If you press the
[ENT]key.
[MENU] key while changing the values on the setting menu, all
the values that has been changed are canceled and it is changed into Display Mode.
To move to the next menu on Display Mode, press the
[MENU]key.
8.2.9 RS-232 / RS-485 DISPLAY
Either RS-232 or RS-485 is selected in this menu for serial communication with the
SCADA system.
16