Download user manuals

Transcript
USER MANUAL
LABELLING:
Sprayers are labelled in the following way:
Example:
AGP 400EN; PA 908; PR1 F/3
AGP…… abbreviation for sprayer
400 …… tank nominal capacity
EN…… version, type
U………air rectifier
PA 908… pump type
PR8F/2EMV…..pressure regulator type PR8 with a high pressure cleaning filter (F) and two diverter EM
valves.
All other technical data for a particular component (pumps, flow regulators …) are found in separate
chapters of this manual. Find technical data for nozzles with charts, and examples of consumption
calculations in chapter 15.
MATERIALS AND RECYCLING
TANK…..PEHD (high-density polyethylene)
MOVABLE TUBES …..RUBBER, PVC
FRAME…..STEEL
VALVES, PRESSURE REGULATOR, NOZZLE BRACKETS ….. mainly PA (polyamide) with glass
fibre
NOZZLE BRACKETS TUBES…..COPPER
MACHINE DISPOSAL
After the machine has served its purpose, it must be completely cleaned, disassembled, sorted according to
the materials of each component, and disposed of to an organisation, dealing with waste. Tank and other
plastic components can be recycled or burnt in waste incinerators; whereas metal parts must be separated
as scrap iron. When dealing with waste, local legislation must be considered.
CONNECTOR FOR PUMP FLOW CONTROL MEASURING
Pump flow indicator can be connected to the pressure regulator return conductor. Tube extension must be
removed; and another extension that is connected to the tank through flow indicator must be assembled to
its place. While doing this, all other pressure regulator supply conductors must be closed to ensure the
whole quantity of the pumped fluid to flow through the return conductor to the tank.
MEASUREMENT OF LIQUID FLOW RATE THROUGH THE NOZZLE
To measure the liquid flow rate through the nozzle, you will need a piece of soft flexible hose with an
inner diameter of 25 mm or 1” and an appropriate container (it is recommended to use a measuring
cylinder). Simply put on the hose on the nozzle and measure the liquid flow rate by catching the liquid of
individual nozzles into the measuring cylinder. You will also need a stopwatch or a wristwatch. The
measurement time is one minute. If you have performed the measurement in less than one minute,
calculate the liquid flow rate to one minute.
If the liquid flow rate of a nozzle at a specific pressure exceeds the table values for more than 10% than
the nozzle insert is worn and needs to be replaced.
AGP 600 EN (U) – AGP 2000 EN (U)
51