Download LittleDog Robot 1.0 - Computational Learning and Motor Control Lab

LittleDog Robot 1.0 User Guide
Removing the Battery:
1.
Once the battery compartment is
open you can lift the battery out
of the compartment.
2.
To disconnect press on the
connectors release tab and the
white connectors will separate,
as shown in Figure 18 (A).
(A)
WARNING: Do not pull on the
connectors without releasing the
latch.
Installing the Battery:
1
Connect the two mating connectors
before installing battery
2
Place the battery in the
compartment, insuring the leads
coming from the battery pack are
pointing down, as shown in Figure
18 (B).
3
Insert the battery door, ensure the
tabs engage at the top of the
compartment. Tilt the battery door
down as shown in Figure 18 (C),
insuring the red and black battery
wires do not get pinched under the
edge of the door.
(B)
Figure 18: Battery Installation
52
(C)