Download DCE™ Rack System - Emerson Network Power

Optional Accessories
3.5 Overhead cable trough: E6016/7016/8016
When ordered with the rack, the troughs ship assembled, but not installed. When ordered separately, the
trough will still ship assembled. The top of the DCE rack has a variety of mounting holes. Place the trough
where you require cable routing. Insert a cage nut into the appropriate square hole on the top panel, and
secure the trough on top with M6 screws. For 600mm wide racks use DCE6016, for 700mm wide racks
use DCE7016 and for 800mm wide racks use DCE8016.
Install where desired; insert M6 cage
nuts into square hole on top panel and
secure trough with (4) M6 screws
3.6 Exhaust Chimney: E1832014/E3246014
The chimney top panel allows an exhaust chimney to be installed. Place the chimney on top of the opening
in the top panel and secure it from inside the rack with four #10-32 x 1/2”L screws. Raise the outer section
of the chimney so the rubber seal touches the ceiling. When the chimney is at the desired height, use a
screwdriver to punch out the appropriate knockout along each side of the chimney; insert the chimney
knob into the knockout to secure the chimney.
• E1832014: Adjustable 18" to 32"H; 18.75"W x 14.3"D
• E3246014: Adjustable 32" to 46"H; 18.75"W x 14.3"D
Use a screwdriver to
punch out appropriate
knockouts; secure with
chimney knob
Fully-extended
Chimney
Fully-compessed
Chimney
20
DCE™ Rack System User Manual