Download Printer for Textiles - Wide Format Printers

Gandinnovations Jeti 3324 AquaJet RTR
19
108. Can you vary the gap (the distance from the printhead to the media, which is the distance the ink droplets must
fly?
Yes you vary the carriage height via software. In order to reduce the chance of crashing the carriage into the media or other obstructions, the carriage height relative to the material being printed on should be manually verified by the operator.
109. What is the nozzle spacing?
The printhead brochure states the nozzle spacing is 508 microns (0.020 in)
CLEANING & MAINTENANCE
110. How is head cleaning accomplished? Spray, vacuum, manual, other?
Cleaning is done by purging. Gandinnovations literature calls it priming.
111. How complex is it to align the printheads?
Vertical alignment of printheads should be performed every time one or all of the printheads have been removed or if the carriage
has crashed against any obstruction. Although you should follow 14 steps to align the heads, it is not complicated.
At the left in the service station you will find a switch to move the capping tray up and down.
112. Is there a capping station?
Yes, and use a layer sarin wrap.
113. How many levels (strengths) of printhead cleaning (purging and/or sucking) can be accomplished via the firmware (software?
Two:
• Quick prime
• Regular prime
114. Can you purge an individual printhead, or do you need to purge all at once?
Yes, you can select what individual printhead to purge, and you can vary length of the purge from ½ to 4 sec.
115. Where is the service station?
Left