Download Manual / Handbuch Spare parts list / Ersatzteilliste - WESCO-Navy
Transcript
Page 38 D. CLEANING/SANITISING INSTRUCTIONS OF WATER SYSTEM Page 38 6. Lift up the entire spray platen from its bottom seat and take it out to clean it separately. Clean-sanitise the water system, evaporator, bin and spray jets using a solution of Ice Machine Cleaner/Sanitizer. NOTE. Cleaning requirements vary according to the local water conditions and individual user operation. Continuous check of the clarity of ice cubes and visual inspection of the water spraying parts before and after cleaning will indicate frequency and procedure to be followed in local areas. 1. Remove the front and top panels to gain access either to the control box and to the evaporator. 2. Make sure that all ice cubes have been released from their cups, then switch OFF the machine at front master button switch. 3. Scoop out all the ice cubes stored into the bin in order to prevent them from being contaminated with the cleaning solution. 4. Remove the plastic cup located on the bottom of sump/freezing chamber to drain out all water and scale deposits. 7. Using a bottle, poor fresh water into the bottom of the sump/freezing chamber to clean out most of scale deposit. 8. Install again the spray platen, the curtain as well as the bottom plastic cup. Cleaning 9. Prepare the cleaning solution by diluting in a plastic container two liters of warm water (45°50°C) with 0,2 liters of Ice Machine Cleaner. 5. Lift up and remove the curtain. WARNING. The Ice Machine Cleaner contains Phosphoric and Hydroxyacetic acids. These compounds are corrosive and may cause burns if swallowed, DO NOT induce vomiting. Give large amounts of water or milk. Call Physician immediately. In case of external contact flush with water. KEEP OUT OF THE REACH OF CHILDREN. 10. Remove the evaporator cover then slowly pour onto the evaporator platen the cleaning solution. With the help of a brush dissolve the most resistant and remote scale deposits in the platen. 11. Switch ON again the machine at front master button switch then push the PC BOARD PUSH