Download E1488A Instrument Memory Module User`s Manual

Transcript
Using Multiple Memory Modules on the Local Bus
The Memory Module has the following Local Bus capabilities when using
multiple modules:
• pass data through one or more modules and store it in another module
• store data in several modules
• output data from several modules
Passing Data
Through Memory
Modules
The following program shows how to pass Local Bus data from a Memory
Module through another Memory Module, and then output the data to the
Local Bus. The first module outputs the data and the second module passes
the data to the Local Bus. The program uses the
VINStrument[:CONFigure]:LBUS[:MODE] command with the GENerate
and PIPEline parameters to output and pass the data, respectively.
The program assumes that data was previously stored into the Memory
Module (use the previous lb_str.c program to store the data) and has a
current TRACe name and length (TRACe:DEFine <name>,<length>).
Note
For simplicity purposes, the first Memory Module in the following program
outputs the data to the Local Bus to the second Memory Module. However,
any module that can output data to the Local Bus can be used in place of the
first Memory Module. If using a different module, substitutethe the
appropriate setup commands of the replacement module for the setup
commands of the first Memory Module.
1. Module 1: Disable the Register-level VME Bus Data Transfer
Mode
VINStrument[:CONFigure]:VME[:MODE] OFF
This command disables the register-level data transfer on VMEbus.
(No need to send this command if the module was previously reset.)
2. Module 1: Reset the Local Bus
VINStrument[:CONFigure]:LBUS:RESet
This command resets the Local Bus Controller circuitry.
3. Set the Local Bus Mode to GENerate
VINStrument[:CONFigure]:LBUS[:MODE] GENerate
This command sets the Local Bus Mode to GENerate to output data
bytes from memory.
Using the Memory Module
49