Download Manual

DUS 6 Digital Ultrasonic Diagnostic Imaging System User Manual
13.2.1.
System Surface Cleaning
To clean the system surface:
1.
Power off the system and disconnect it from power supply.
2.
Use a clean gauze pad or lint-free cloth, moistened lightly with a mild detergent, to wipe the
surface.
3.
After cleaning, reconnect the system to power source.
CAUTION
:
Make sure the cleaning solution does not seep into the control panel or any other
openings.
NOTES:
Take particular care when cleaning the areas near track ball and the slide controls.
Make sure they are free of gel and any other visible residue.
13.2.2. Probe and Probe Holder Cleaning and Disinfection
To clean probe holder:
1. Turn the probe holder upwards and then lift the holder out of the system enclosure.
2. Wash the holder with flowing water, using a mild detergent.
3. After cleaning and drying, turn the holder downwards to lock it.
Figure 13-1 Probe Holder
Figure 13-2 Probe Holder Pothook
Probe cleaning and/or disinfection:
‹ C363-1, L743, C321, and C343-1:
Every time before using it, layer of medical ultrasound coupling gel should be applied evenly
on the area of the acoustical window of the probe, and the instrument is ready for operation.
Be careful not to generate any air bubble. Disinfection should be performed each time after
- 123 -