Download Manual

Synth1 Virtual Analog v1.12 2010.5.23
P a g e | 62
41 - lfo1 destination
1 - 7 [default value 2]
This is used to set which parameter the LFO should affect:
1 - osc2
This routes the LFO to the pitch of Oscillator 2 only. This can for example be used together with
Sync to create a “pulsating” change in timbre.
2 - osc1&2
This routes the LFO to the frequency of both Oscillators, in equal amounts. Together with the
Triangle waveform this creates traditional vibrato.
3 - filter
This routes the LFO to the Filter Frequency. This can for example be used for wah-wah effects
(Triangle wave) and for auto repeating sounds (Sawtooth wave).
4 - amp
When this is selected, LFO produces a wave routed to the volume, for tremolo effects.
5 - p/w
This routes the output of the LFO to the Pulse Width of both Oscillators. For this to have any
effect, Pulse wave must of course be selected for at least one of the Oscillators. This destination
can be used with an LFO Triangle waveform to create a “chorus-like” sound, suitable for strings
and pads.
6 - FM
This routes the LFO to the FM Amount, for special timbre changes.
7 - pan
This routes the LFO to the Pan, for special Pan effects.
Copyright © 2010 by Daichi. All rights reserved. This document is a private copy.