Download Regulation 95

Transcript
France
Draft proposal
ELSA-7-04
6.1.1. consider that the modifications made are unlikely to have an appreciable adverse
effect and that in any case the vehicle still complies with the requirements, or
6.1.2. require a further test report from the technical service responsible for conducting
the tests;
6.1.2.1. Any modification of the vehicle affecting the general form of the structure of the
vehicle or any variation in the reference mass greater than 8 per cent which in the
judgement of the authority would have a marked influence on the results of the test shall
require a repetition of the test as described in annex 4.
6.1.2.2. If the technical service, after consultation with the vehicle manufacturer,
considers that modifications to a vehicle type are insufficient to warrant a complete retest
then a partial test may be used. This would be the case if the reference mass is not more
than 8 per cent different from the original vehicle or the number of front seats is
unchanged. Variations of seat type or interior fittings need not automatically entail a full
retest. An example of the approach to this problem is given in annex 8.
6.2. Confirmation or refusal of approval, specifying the alteration, shall be communicated
by the procedure specified in paragraph 4.4. above to the Parties to the Agreement which
apply this Regulation.
6.3. The competent authority issuing an extension of approval shall assign a series
number to each communication form drawn up for such an extension.
7. CONFORMITY OF PRODUCTION
The conformity of production procedures shall comply with those set out in the
Agreement, Appendix 2 (E/ECE/324-E/ECE/TRANS/505/Rev.2), with the following
requirements:
7.1. Every vehicle approved under this Regulation shall be so manufactured as to
conform to the type approved by meeting the requirements set out in paragraph 5 above.
7.2. The holder of the approval shall ensure that for each type of vehicle at least the tests
concerning the taking of measurements are carried out.
7.3. The authority which has granted type approval may at any time verify the conformity
control methods applied in each production facility. The normal frequency of these
verifications shall be once every two years.
8. PENALTIES FOR NON-CONFORMITY OF PRODUCTION
8.1. The approval granted in respect of a vehicle type, pursuant to this Regulation, may
Page 11