Download Manual - Korenix

4.11 Warning
JetNet 5728G provides several types of Warning features for you to remote monitor the
status of end devices or the change of your network. The features include Fault Relay,
System Log and SMTP E-mail Alert.
Following commands are included in this group:
4.11.1 Fault Relay
4.11.2 Event Selection
4.11.3 Syslog Configuration
4.11.4 SMTP Configuration
4.11.5 CLI Commands
4.11.1 Fault Relay
JetNet 5728G provides 1 digital output, also known as Relay Output. The relay contacts
are energized (open) for normal operation and will close under fault conditions. Fault
conditions include Power Failure, Ethernet port Link Failure, Ping Failure and Super Ring
Topology Change. You can configure these settings in this Fault Relay Setting. Each
Relay can be assigned 1 fault condition.
Relay 1: Click on checkbox of the Relay 1, then select the Event Type and its parameters.
Event Type: Dry Output, Power Failure, Link Failure, Ping Failure and Super Ring Failure.
Each event type has its own parameters. You should also configure them. Currently, each
Relay has one event type.
Event Type: Dry Output
On Period (Sec): Type the period time to turn on Relay Output. Available range of a
period is 0-4294967295 seconds.
Off Period (Sec): Type the period time to turn off Relay Output. Available range of a
106