Download CAN-100 - Fujitsu

AN07-00180-3E
Connect the USB cable included in the kit to a USB port on the PC and the USB port on the board. Be
sure to directly connect between them without using a USB hub.
Connect a USB port on the PC.
For information about port locations and so forth, refer to the manual of the PC.
USB port
After SOFTUNE installation,
connect the USB cable.
Figure 1-24 Connection between the PC and the board
The power of the board is supplied via USB (USB bus power).
[Note]
If a driver installation dialog is displayed after connecting the board to the PC, USB drivers
may be incorrectly installed.
Install drivers according to the USB driver installation manual.
- 34 -