Download EMX2 User Manual - AuCom Electronics

ELECTRICAL SPECIFICATION
SPECIFICATIONS
The following specifications are common to all models:-
Power Circuit:
Reverse parallel connected thyristors (full wave control)
Supply Voltage:
220 VAC to 600 VAC (3 Wire)
220 VAC to 440 VAC (6 Wire)
Consult local representative for other voltages
Supply Frequency:
48Hz to 52Hz, 58Hz to 62Hz
Control Voltage:
Refer Marking On Equipment
Fan Voltage:
Refer Marking On Equipment
Current Rating:
Refer to Table Of Ratings overleaf
Motor Connection:
3 Wire or 6 Wire
Control Inputs:
Active 24 VDC, 8mA approx
(C13,C14) FLC Select
(C23,C24) Start
(C31,C32) Stop
(C41,C42) Reset
Relay Outputs:
5A @ 250VAC/360VA, 5A @ 30VDC Resistive
(23,24)
Run (Bridging Contactor Control) (N.O.)
(13,14)
Main Contactor Control (N.O.)
(33,34)
Start/Run (N.O.)
(41,42,44) Trip (C/O)
Indicators:
Power On, Start/Run, Run, Overload, Phase Sequence, Overcurrent,
Undercurrent, Phase Loss, Thermistor, Shearpin, Installation Fault,
Overtemperature Fault
Environmental:
Degree of Protection: IP00
Form Designation: Form 1
Rated Insulation Voltage: 2 kV
Rated Impulse Voltage: 2 kV
Pollution Degree: 3
Rated Short-circuit Current: 50 kA
Equipment Class (EMC): Class A.
This product has been designed for Class A equipment. Use of the
product in domestic environments may cause radio interference, in
which case the user may be required to employ additional mitigation
methods.
Ambient
Temperature:
0oC to 45oC (Operating)
-5oC to 65oC (Storage)
Approved To:
UL508
CSA 22.2 No 14.
C9 (CISPR-11)
CE (IEC947-4-2)
EMX2 SERIES
4-2
USERS MANUAL