1
Download User Manual Chapter 07 - Chapter 13
Transcript
C H A P T E R • 1 0 S T E E L D E S I G N Launch the steel design by clicking the icon . The iterative process will start by the modal and spectral analyses and then, the steel shapes will be modified. During this process, the software automatically considers maximum modal contributions. Main vibration modes are modified in the Linear Seismic Directions spreadsheet, if they changed. Results • Go to Results / Spectral/Modal and open the Levels spreadsheet. Check interstory drifts. • Activate the View Options and display the member design loads. • Consult steel design results (Results /Structure Design /Steel). . • Select the Seismic Design Results spreadsheet (Results /Structure Design /Steel - seismic Design). Convergence • If the convergence is not easy to reach, increase the number of correction cycle to 5-7. (Analysis tab – Project Configuration). See also Commentary on Seismic Design Requirements-Clause 27-CAN/CSA-S16-01 Member Usages for Seismic Design Steel Design Results Design Brief Seismic Design Results CivilDesign inc. Engineering Software 10-91
