Download Downloading - DSF Technologies

Transcript
DYNA 326
DPG-2201-001 User Manual
Page 23
Troubleshooting Table continued
SYMPTOM
REMEDY
Engine takes too long to reach the
set speed.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Engine Does Not Track Speed
Setting Changes
Excessive Smoke at Startup
Sluggish Response to load
changes
Engine Instability With No-load
Engine Instability With Load
Engine Unable to Carry Rated
Load
Load Sharing Does Not Work
•
•
•
•
•
•
Droop Does Not Work
•
•
•
•
Improve PID tuning.
Integral setting is too low.
Startup Rate setting is too low.
Accel Rate setting is too low.
Speed Filter setting is too high.
Is the LED decimal point blinking? If not enter password.
Is the selected set speed parameter being modified?
A PID value or an OVG value is too high.
A PID value is too low or zero.
Accel Rate is set too low.
Decel Rate is set too low.
Improve PID tuning.
Use a lower Startup Rate setting.
Use a lower Startup Limit setting.
Low MPU signal voltage. It should read 2.0VRMS minimum.
Gain too low.
Improve PID tuning.
Speed Filter setting is too high.
Improve PID tuning.
Speed Filter setting is too low.
Fuel is restricted. Check actuator linkage.
Battery voltage is too low.
Improve PID tuning.
Fuel is restricted. Check actuator linkage.
Battery voltage is too low.
PID values may be too high causing the governor to over react and make
large rapid changes in PWM duty cycle output to the actuator.
Improve PID tuning.
Torque Limit is set too low. Increase the Torque limit.
Fuel is restricted. Check actuator linkage.
Measure the ILS input signal to see if the measurement is between 2.375
and 2.625 volts DC.
Use shielded wiring
If the application requires more than ±3% of speed change around the set
speed then use a DPG-2401-001 controller instead.
The No Load and Full Load values are not calibrated. Perform the Droop
Calibration Procedure.
Difference between No Load and Full Load calibration values is too
small. Should be > 100 for best performance.
Modify or adjust actuator linkage to increase range of actuator loading.
If finer droop control is required, then use a DPG-2401-001 controller
instead.
© Copyright 2000-2003 Invensys. All Rights Reserved