Download XSTABL Reference Manual

ERROR 38
The program calculated a point for the PASSIVE wedge that is outside
the defined slope geometry. The analysis will continue, but the user
should adjust the search box or slope geometry to allow a passive
wedge to be formed from all points within first box.
ERROR 39
The program calculated a point for the ACTIVE wedge that is outside
the defined slope geometry. The analysis will continue, but the user
should adjust the search box or slope geometry to allow an active
wedge to be formed from all points within last box.
SPECIFIC SURFACE
ERROR 40
The above trial surface point is out-of-sequence with respect to the
points specified prior to it. Points defining the trial surface must
be specified in a sequential toe-to-crest order. Please check the
sequence of the specific surface data before retrying the analysis.
ERROR 41
One of the points specifying the above trial surface is OUTSIDE the
extent of the defined ground surface profile. All points defining a
trial failure surface must be within the horizontal extent of the
defined ground surface. Please check coordinates before retrying.
ERROR 42
The x-coord of the first point lies to the LEFT of the defined ground
surface profile. This value must EXIST within the defined slope
geometry. Please make sure that the x-coord of this initial point
is to the RIGHT of the left-end of the first surface segment.
ERROR 43
On the basis of the information provided for the generation of a
single circular surface, some coordinates were calculated OUTSIDE the
range of the defined slope geometry. Please check the input data, or
review the slope geometry using the F2 option.
ERROR 44
The segment length for the requested failure surface(s) has been set
as 0.0 (zero). The analysis has been terminated as the problem
cannot be analyzed using a zero segment length. Please check the
slope geometry data before repeating analysis.
XSTABL Reference Manual
157