Download FA-UNIT-H4BE

3. Installing the Backplane
(3) Attach the drive to the 2.5-inch drive bay.
Connect the cables and fix them to the original position of the chassis.
Connect the 2.5 inch drive with the SBC using the supplied cable (IDE signal conversion cable).
(4) Return the fall-off prevention bar and cover to their original positions and fix them with screws.
Installing/Removing a fan and filter
You can install/remove a fan and filter, without removing the top cover.
Relay connector
Finger guard
FAN
Filter
FAN cover
* The installation of the fan is obtained in the reverse order of removing.
Figure 3.1.
16
Installing/Removing a fan and filter
FA-UNIT-H4BE