Download Wireless Cable Gateway CG3100D
Transcript
NETGEAR Wireless Cable Gateway Gateway Rear Panel USB port Voice ports Ethernet LAN ports Coaxial cable connector Power adapter input Power On/Off button Figure 2. Gateway rear panel The rear panel includes the following connections, viewed from left to right: • Two voice/phone ports. WIth VoIP service, connect one or two handsets to these ports. • Four Gigabit-Ethernet LAN ports. Use these ports to connect local computers. • USB port: The USB port is a USB host and can be used for connecting a USB printer. Note: USB functionality is only available with future firmware upgrades. • Power. Power adapter input. • Power On/Off button. Note: You can return the gateway to its factory settings. On the bottom of the gateway, press and hold the Restore Factory Settings button for over 7 seconds. The gateway resets, and returns to its factory settings. See Factory Default Settings in Appendix A. Install the Voice Gateway Installation is the four-step process summarized here and described in the headings that follow. Make sure you complete the installation in this order. 1. Check the Installation Requirements. 2. Cable the Gateway. 3. Log in to the Gateway. 4. Connect to the Internet.and VoIP. After installation, set up the wireless connection as explained in Chapter 2, Wireless Configuration. Connect to the Internet 7